P-CB7XC Futaba T7XC 2.4GHz mit R334SBS Empfänger Original Futaba Ersatz-/Tuningteil. Professionelles 7-Kanal 2.4 GHz Fernsteuersystem für RC-Cars mit 4,3 Zoll Farb-Touchdisplay! Ultraschnelle Signalübertragung T-FHSS SR und ein neuer 2.4GHZ R334SBS 4-Kanal Empfänger mit 2 Antennen zeichnen dieses System aus. Die außenliegende Antenne sorgt für optimale Abstrahlung der Sendeleistung in allen 3 Modulationsarten. T-FHSS-SR, 4 Steuerkanäle ohne Telemetrie, jedoch mit maximaler Response Speed. T-FHSS, 4 Steuerkanäle mit Telemetrie. S-FHSS, 7 Steuerkanäle ohne Telemetrie. FASST, 4 Steuerkanäle ohne Telemetrie. Das neue T-FHSS SR (Super Response) System ist schneller als alle bisherigen auf dem Markt befindlichen Übertragungsarten. Mit 2,45 ms ist die Response Speed im Modell spürbar schneller geworden (T-FHSS = 4,15ms). Optisches Zentrum der T7XC ist das hintergrundbeleuchtete 4,3 Zoll große TFT Farb-Touchdisplay mit brillanten Farben und hoher Schärfe. Auch bei direkter Sonneneinstrahlung lassen sich alle Werte auf dem Display hervorragend ablesen. Die grafisch geführte Benutzeroberfläche mit der bekannt einfachen Futaba-Menüstruktur, sorgt für eine leichte Bedienung. Die Navigation erfolgt intuitiv über den Bildschirm und die Zusatztasten auf der Senderoberseite. TELEMETRIE-FUNKTIONEN Synchronisierte, bidirektionale Kommunikation zwischen Sender und Empfänger mit hoher Telemetrie Datenrate (bis zu 9 mal pro Sekunde), ohne Responseverlust der Steuerkanäle. Maximal 31 Telemetrie-Sensoren, Alarmton-Einstellung und Ausgabe über Beeper, Vibrationslalarm oder Sprachausgabe per internem Lautsprecher oder optionalem Kopfhörer/Aktivlautsprecher. Telemetrie-Datenaufzeichnung auf SD-Karte (SDHC). Tabellenkalkulationsprogramme oder LogView Software. Echtzeitanzeige der Telemetriedaten auf integriertem Display. Empfängersignalstärke-Anzeige zur Überwachung der Reichweite. Empfänger-Unterspannungswarnsystem zur Überwachung des Empfängerakkus. BUS2 Eingang für z. Drehzahl (optisch oder magnetisch). Temperatur (125°C oder 200°C). GPS (Geschwindigkeit und Distanz). Empfänger R334SBS mit vier normalen Servoausgängen sowie S. BUS-Servos auch an normalen Servoausgängen des Empfängers anschließbar. Digitale BUS-Technologie für den Modellsport. Erlaubt ideale Platzierung aller Komponenten mit effizienter Verkabelung. Zukunftssichere, digitale Technologie für alle künftigen Futaba-Komponenten. T-FHSS SR/ T-FHSS: R334SBS/ R334SBS-E. S-FHSS: R2104GF/ R204GF-E/ R2008SB/ R2006GS. FASST: R614FS/ R614FF-E/ R604FS/ R604FS-E. 7-Kanal Computer-Fernsteuersystem mit T-FHSS SR / T-FHSS / S-FHSS / FASST(C2) 2.4 GHz Technologie. Telemetrie Funktion (nur bei T-FHSS). Zukünftige NFC Funktion für kontaktlose Updates mit Android Geräten. Hintergrundbeleuchtetes 4,3 Zoll Farb-Touchdisplay. Displayanzeigen deutsch, englisch od. 40 interne Modellspeicher, erweiterbar per SD-Karte. Dual Rate & Exponential Funktion. Speicher Reset und Kopie. Modellname bis 15 Zeichen. Benutzername bis 15 Zeichen. Failsafeeinstellung für Kanäle 1-4, B-F/S für Gasfunktion. Schnellste Reaktionszeiten mit Digital-Servos. Freie Wahl der Zuordnung von Schaltern und Gebern. Kanäle: 4 / 7(bei S-FHSS). Übertragungssystem: T-FHSS SR / T-FHSS / S-FHSS / FASST(C2). Frequenzband: 2.4 GHz. HF Sendeleistung: 100 mW EIRP. Response Speed: 2,40 ms. Spannungsversorgung: 6,0 – 7,4 V. P-CB7XC Futaba T7XC 2.4GHz with R334SBS receiver Genuine Futaba spare/option part. The T7XC was developed for car/boat modellers who want a premium stick style radio for land and water based modelling. The technology inside is largely based on the well known T7PX with some new features and this stylish new ergonomic case shape. The case is made from high quality moulded plastic and finished in a stunning deep satin black, accented by chrome mouldings and switches. The huge 4.3 colour touch screen has a’transflective’ surface for great visibility indoors and out. The screen is easy to use and responds quickly to the touch. There is also a jog dial if you prefer to navigate that way. Using Futaba’s fastest technology’T-FHSS SR’ the response has a ultra-fast frame rate of 2.45 milliseconds! This new system brings in a locked in feel and response that racers and performance drivers will truly appreciate. The T7XC is also compatible with Futaba T-FHSS, S-FHSS and FASST so you can select the preferred transmission system for each car to suit your requirements and budget. With T-FHSS telemetry the data can be displayed on the screen or relayed by a synthesized voice using the in-built speakers or headphones (not included). Just another way that Futaba is at the forefront of technology to make your hobby easier. Full Colour Touch Screen LCD Right in the center the T7XC has a HVGA 4.3, full-colour, backlit LCD touch screen. The screen is transflective to improve both indoor and outdoor visibility. T-FHSS SR (Super Response) & Telemetry T-FHSS In addition to the T-FHSS telemetry system, the T7XC has the new T-FHSS SR (Super Response) system with an ultra-fast processing speed to further improve control response. (Note: The SR system does not support telemetry function) Updateable Software The T7XC software can be updated easily using a microSD card. You can also save your model data to a microSD card and even save your telemetry log data. Model memory for 40 models The T7XC has 40 model memories and each can use names with up to 15 letters, numbers or symbols. You can even copy a model memory and modify the setup for different applications using the built in model copy function. Integral Type Dial Switch A switch with both dial (DL1) and switch (SW6) function are combined into one smart unit. Brake Mixing for Large Cars There is a built in brake mixing function allowing you to adjust bias between the front and rear wheels of 1/5 GP and other large cars with lots of adjustability. Steering mixing Smooth cornering is also possible by mixing independent left and right steering servos precisely. 4WS Mixing for Crawlers and other 4WS Cars This function is most popular on rock crawlers but ti is also suited to other 4-wheel steering vehicles. Dual ESC Mixing for Crawlers You can control front an rear ESC independently in advanced rock crawlers. Gyro Mixing The sensitivity of Futaba car gyros can be adjusted from the T7XC directly. Tank Mixing This dual track mixing function is intended for vehicles such as tanks. CPS Mixing LED lighting and flashing control using the Futaba CPS-1 channel power switch can be matched to steering and throttle operation using a switch. BUS Servo Settings This is a special S. Bus function allows you to adjust/set parameters of certain Futaba S. Futaba MC-Link You can adjust parameters of certain Futaba speed controller MC960CR, MC950CR, MC850C, MC851C, MC602C, MC402CR, etc. Throttle Speed With modern high performance RC cars the sudden application of power on a slippery road surface will only cause the tires to spin and reduce drive. This setting allows you to adjust the throttle speed setting to apply power smoothly and easily. It also helps to reduce battery consumption. Steering Speed When you sense that a steering servo is too fast and you are loosing grip you can adjust the speed to help regain smooth control. Non-telemetry LED A LED will light to alert to you that the telemetry function is OFF and not operating. Dial Select Function This function allows you to assign specific functions to different controls (digital trim, dials or switches). You can also adjust the step (sensitivity) amount and change the operating direction. Trim/Dial Lock Functions You can lock specific functions to prohibit accidental adjustment. Vibrator Built into the Grip The vibrator can be set to activate using the racing timer lap navigation, time-up, a telemetry alarm or low battery warning. Display backlight brightness setting / dimming time setting / touch panel correction. Information language setting / version information. Sound setting (telemetry sound, alarm sound, operating sound). Battery type setting / auto power off. Date and time setting / Displaying the time on the home screen or selecting the total timer. Steering wheel and throttle trigger calibration. Software update with NFC. Receiver update using Tx (R334SBS / R334SBS-E). Model memory name (set / modify). Delete model data in SD card. Data reset (Model, Direct menu, All). Receiver system / servo response selection / linking with T-FHSS SR & T-FHSS system receive / Telemetry ON / OFF. Servo view, displaying servo operation. Trigger neutral, brake and throttle servo rate adjustment. Sub trim, fine adjustment of the center position. Acceleration, changes the’lag time’ of the throttle from the neutral position. Trim / Dial selection. Switch select, select which functions are operated. Condition, 2nd condition settings. Idle up at engine start. D/R, ATL, Steering angle adjustment while running / Brake side adjustment. Channel Limiter, a channel limiter function which limits maximum servo movement. Channel Setting, ability to assign steering or throttle motion to any channel. Curve (EXP), Steering curve adjustment / Throttle curve adjustment. Servo speed, steering servo delay / Throttle servo delay. Traction control, Pulse throttle operation to improve grip. Start throttle, preset at start function. Engine cut, engine cut off by switch. Steering mixing, Twin servo mixing of the steering. Brake mixing, front and rear independent brake control for 1/5GP car, etc. Gyro mixing, The sensitivity of Futaba car rate gyros can be adjusted. Dual ESC, front and rear ESC mixing. CPS mixing, for Futaba CPS-1 LED controller. Tank mixing, for use in RC military tanks. Tilt mixing, outboard engine tilt mixing. Timers (up, down, lap, or lap navigation timers). Lap timer data (lap time, average lap, best lap time) check. BUS servo Link software setting / SR mode setting. MC (ESC) Link (for MC851C/602C/402CR/950CR/940CR/960CR). Gear ratio calculation function. Home (change the function of the HOME button). T-FHSS SR/T-FHSS (Default) – R334SBS/ R334SBS-E. T-FHSS – R304SB/ R304SBE. S-FHSS – R2104GF/ R204GF-E/ R2008SB/ R2006GS. FASST – R614FS/ R614FF-E/ R604FS/ R604FS-E. Note: R3008SB & T-FHSS Air system receivers do not operate. Im übrigen verweisen wir auf unsere OnlineShop-AGB. RC-Car-Shop Hobbythek in Krefeld. Der weltgrößte RC-Car Großmodellspezialist. Mehr als 1000 RC-Car Modelle im Maßstab 1/5 und 1/6 und 15.000 verschiedene Artikel auf Lager und versandbereit. Widerrufsrecht finden Sie auf unserer -Seite. For further information, please refer to our online shop terms and conditions. The Worlds Largest Model RC car wholesale specialist. Additional information (right of revocation) are available on our -page. Online For extra-judicial settlement of consumer disputes, the European Union has set up an online platform (OS platform), to which you can turn soon. The item “Futaba T7XC 2.4GHz + R334SBS Empfänger, P-CB7XC Fernsteuerung RC system receiver” is in sale since Monday, August 6, 2018. This item is in the category “Modellbau\RC-Modellbau\RC Modellbau Teile & Zubehör\Fernsteuerung & Elektronik\Sender & Empfänger”. The seller is “auktionsshop-hobbythek” and is located in Krefeld, NRW. This item can be shipped worldwide.
- Marke: Futaba
- Geeignet_für_Maßstab: 1:4
- Herstellernummer: P-CB7XC
- Produktart: Empfänger
- Modell: T7XC
- Frequenzbereich: 2,4GHz
- Angebotspaket: Ja